4Wheel Drive & Sport Utility Homepage
Home»Technical»Installing PRP Seats - Back in the Saddle»Photo 9

Prp Suspension Seats Drill Hole

Once we determined the rail length required, we drilled out the four 3/8-inch holes in the slider stud mount rails that will tie in the front and rear stock seat hole supports.
Installing PRP Seats - Back in the Saddle

 Once we determined the rail length required, we drilled out the four 3/8-inch holes in the slider stud mount rails that will tie in the front and rear stock seat hole supports.  View Related Article

 

Car Research Guide