With the Yukon Gear Ultimate...
With the Yukon Gear Ultimate 35 kit and OX Locker installed, this Dana 35 rear axle will be able to put up with quite a bit more abuse than it would in stock form.
Yukon Gear & Axle's Ultimate 35 kit includes everything you'll need to upgrade your Dana 35 rear axle. Included in the kit are a set of chrome-moly alloy-steel axleshafts with new wheel studs and a Yukon Super Installation kit with new wheel bearings, shims, and all of the necessary setup items. The Yukon Ultimate kits can also be packaged with a locker of your choice. We elected to use an OX Locker from OX-USA for this installation. Ultimate kits are available for both bolt-in and C-clip Dana 35 axles as well as for Jeep Dana 44 applications.
The Yukon alloy axleshafts are offered in 27-spline and 30-spline, depending on your needs. Stock Dana 35 shafts are 27-spline, so the 27-spline alloy axleshafts are a good way to go if you already have a locker installed. If you upgrade to 30-spline axleshafts, you'll need to install a new 30-spline carrier or locker as well, but increased strength will be afforded. Even if you opt to go with the 27-spline axleshafts, however, you're still getting a much stronger shaft over stock. The Yukon alloy axleshafts are more resistant to normal wear and are less likely to bend or twist than stock axleshafts. Depending on the application, you can expect approximately 30 percent more strength from Yukon alloy axleshafts over OEM carbon-steel shafts.
For on-demand axle-locking capability, we installed the cable-actuated OX Locker. The OX Locker is constructed in the USA from 8620 forged and heat-treated steel and uses four spider gears with a back-cut gear-tooth design. The OX Locker includes an aerospace-quality, aluminum cable shifter mechanism and a unique forged-steel ramped differential cover that features an integrated shifter-fork mount. When the cab-mounted shifter is engaged, the cable moves the shift fork in the differential cover, which slides a collar over one of the side gears to lock it in place. This creates a spool-like locking effect for increased traction to both rear wheels. Once the shifter is disengaged, the OX Locker operates like an open differential again. In addition to the Dana 35 OX Locker, units are available for Dana 30, Dana 44, Dana 60, AMC 20, and Ford 8.8 axles.
 The Yukon Ultimate 35 kit...  The Yukon Ultimate 35 kit includes 30-spline alloy axleshafts and an installation kit with new bearings and seals, shims, lug studs, and a cover gasket. We also acquired a set of Yukon 4.56 gears for the Dana 35, as well as for the front Dana 30. |  The OX Locker from OX-USA...  The OX Locker from OX-USA will permit increased trail capability. This 30-spline unit included a 70-inch cable, a shifter, and a forged-steel differential cover. |  The OX Locker is manufactured...  The OX Locker is manufactured from 8620 forged and heat-treated steel. It is a stout unit capable of withstanding plenty of abuse and will offer on-demand positive-locking engagement. This unit arrived assembled but required partial disassembly for installation of the ring gear and the C-clips. |